Plumbing & water
Water Meter Automatic Assembly Line
A connected production system for component feeding, meter assembly, inspection and finished-product handling.
Production challenge
Water-meter production involves small sealing, transmission and housing components whose orientation and assembly integrity must remain consistent across high-volume production.
Dading solution
The system organises component feeding, meter assembly, monitored fastening, inspection and automatic result sorting. Fixtures and inspection points are defined around the exact meter construction and target quality controls.
System in operation
See the system in operation.
Project footage of the water meter automatic assembly line.
Project media gallery
Explore machine and product details in the gallery.
System sequence
Production sequence: Water Meter Automatic Assembly Line
Repeatable assembly and inspection for high-volume water-meter production.
- 01Component feeding
- 02Meter assembly
- 03Torque control
- 04Inspection
- 05Result sorting
Engineering priorities
The details that protect output and quality.
The final machine architecture is confirmed against customer samples, drawings, applicable standards and the agreed acceptance protocol.
Small-part feeding
Meters, seals and internal components are presented in the required orientation.
Monitored assembly
Critical fastening and presence conditions are checked during the process.
Integrated inspection
Functional or dimensional checks can be placed at the appropriate quality gates.
Flexible output
Recipe and tooling concepts can support the agreed meter size family.
Representative configuration
Configured around the product and target.
The configuration below describes the intended project architecture. Final cycle, test accuracy, footprint, staffing and equipment brands are confirmed during concept engineering and FAT definition.
- Application
- Water-meter component and housing assembly
- Automation scope
- Feeding, assembly, inspection and sorting
- Typical cycle target
- Approximately 5 seconds per part
- Quality checks
- Presence, fastening and specified functional inspection
- Variant approach
- Change tooling and recipes based on model range
- Data connection
- MES/ERP interface available through agreed protocol
Define your version
What Dading confirms with your engineering team.
- Meter construction and size range
- Sealing and torque requirements
- Required functional checks
- Labelling and traceability format
Discuss your project
Discuss a system built around your part.
Share your part drawings, target output and quality requirements. Our engineering team will help define the right automation concept.
Discuss your project